janome dc2010 manual pdf

The Janome DC2010 is a computerized sewing machine with 20 built-in stitches, automatic needle threader, drop feed for free-motion sewing, built-in buttonhole, adjustable stitch length and width, top drop-in bobbin system, and free arm capability. Below are key sections for safety, features, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Computerized control panel, automatic needle threader, drop feed lever, free arm, accessory storage, built-in LED light.

Unpacking and Setup

Unpack and inspect all contents. Place on stable surface.

1. Remove machine from packaging: Lift carefully from carrying case.
2. Attach power cord: Plug into machine and wall outlet.
3. Install foot controller: Connect to machine port.
4. Set up accessories: Place in built-in storage compartment.
5. Install needle: Use screwdriver to secure needle properly.

WARNING! Machine is heavy; lift with care to avoid injury. Ensure stable surface placement.

First-Time Operation

Power on machine; follow setup procedures.

1. Thread machine: Follow threading path indicated on machine.
2. Wind bobbin: Use built-in bobbin winder.
3. Insert bobbin: Place in top drop-in bobbin case.
4. Select stitch: Choose from 20 built-in options.
5. Test sew: Use scrap fabric to check tension and stitch quality.

CAUTION! Keep fingers away from needle during operation. Always turn off when not in use.

Specifications

• Stitches: 20 built-in utility and decorative
• Buttonhole: One-step automatic
• Needle Threading: Automatic push-pull system
• Bobbin System: Top drop-in with clear cover
• Stitch Length: Adjustable up to 4mm
• Stitch Width: Adjustable up to 5mm
• Feed System: Drop feed for free-motion sewing
• Free Arm: Yes, for cylindrical sewing
• Lighting: Built-in LED
• Power Supply: Standard household outlet

Controls and Functions

Access controls via front panel and dials. Main Panel: Stitch selection dial, stitch length dial, stitch width dial, reverse stitch button.

Additional Controls: Power switch, foot controller port, bobbin winder, drop feed lever, automatic needle threader.

Stitch Selection: Turn dial to choose from 20 stitches. Stitch Length: Adjust from 0-4mm. Stitch Width: Adjust from 0-5mm. Reverse: Hold button for reinforcement stitching. Drop Feed: Lower for free-motion work.

Stitch Selection

20 built-in stitches including straight, zigzag, stretch, and decorative.

1. Turn stitch selection dial to desired pattern number.
2. Adjust stitch length for fabric type and purpose.
3. Set stitch width for decorative effects.
4. Test on scrap fabric before sewing project.
5. Use reverse button to secure stitches at beginning and end.

Tip: Refer to stitch guide on machine for recommended settings.

Threading and Bobbin

Automatic needle threader and top-loading bobbin system.

1. Raise needle to highest position using handwheel.
2. Follow numbered threading path on machine.
3. Use automatic needle threader: Push down, hook thread, pull through.
4. Wind bobbin: Place thread on spool pin, wrap around tension disc.
5. Insert bobbin: Drop into case with thread flowing counterclockwise.

WARNING! Ensure machine is off during threading. Keep fingers clear of moving parts.

Maintenance & Cleaning

Unplug before maintenance. Clean lint regularly from bobbin area and feed dogs.

CAUTION! Use only recommended sewing machine oil. Never spray cleaners directly on machine.

Regulatory Information

FCC compliant for home use. Copyright © Janome. For support, visit www.janome.com or contact authorized service centers. UL listed for electrical safety.

Troubleshooting

Service: Contact authorized Janome service center for repairs.